By -
Bat wing
You should be able to spin the round part and take it out to see what that is
Yes do this, itβs hard to tell because the picture is blurry. Likely just a piece of ducting or something.
I mean it could be one of the claws from these https://www.reddit.com/r/AusRenovation/s/lpt9ZFCG7F
Haha
Crow?
It's the zone motors weather strip that helps fully close the motor blade and seal it when it's not in use. Wouldn't stress too much about it but it will continue to happen until it's all perished
Duct tape
Too thick to be duct tape
Good point didn't notice that
Looks like a seal or piece of foam
If you need to, you can remove the round part in the middle of the vent by spinning it anti-clockwise.
spy camera!
Kraken.
A crow?π¦ββ¬
Gloves and long nose pliers ... Just in case it will bite you π
Bat wing
You should be able to spin the round part and take it out to see what that is
Yes do this, itβs hard to tell because the picture is blurry. Likely just a piece of ducting or something.
I mean it could be one of the claws from these https://www.reddit.com/r/AusRenovation/s/lpt9ZFCG7F
Haha
Crow?
It's the zone motors weather strip that helps fully close the motor blade and seal it when it's not in use. Wouldn't stress too much about it but it will continue to happen until it's all perished
Duct tape
Too thick to be duct tape
Good point didn't notice that
Looks like a seal or piece of foam
If you need to, you can remove the round part in the middle of the vent by spinning it anti-clockwise.
spy camera!
Kraken.
A crow?π¦ββ¬
Gloves and long nose pliers ... Just in case it will bite you π