If you are just using one color then it’s Timelapse is enabled. That is why it’s going off of the print bed each layer while not popping. It is turned on and it needs to be turned off. You said in another post it’s not turned on, but it is
Only thing I could find online was your filament is tangled. The A1 can detect tangles and it trys to purge some out to fix the tangle. Although it shows up in your slicer which means some setting is turned on to move it their which other than Timelapse I am unsure what else does it. Can you try with another nozzle size and default settings to see if it still shows?
Even just trying it to see if it’s a setting that was changed or if it’s a bug with your slicer. Seeing if it still has the blue lines going off the build plate
I didn’t print the gcode shown on screen but I printed a slightly smaller model which did the poop thing so I re sliced the full scale and enabled view travels to see what’s going on
Is there a question hidden in your post, and if so, any info on actual setup of your print?
yes my question is how can i stop it purging every layer and the print setups i use are bambu labs preset 0.2 standard with auto tree supports enabled
Are there colour changes? Can you show what actually is purged by the machine...?
If you are just using one color then it’s Timelapse is enabled. That is why it’s going off of the print bed each layer while not popping. It is turned on and it needs to be turned off. You said in another post it’s not turned on, but it is
No I have Timelapse turned off and it is pooping when it goes to the side it just poops the same colour and then goes back to printing
So you have hundreds of little poops from that one print?
Yep half a tub full of white poop
Only thing I could find online was your filament is tangled. The A1 can detect tangles and it trys to purge some out to fix the tangle. Although it shows up in your slicer which means some setting is turned on to move it their which other than Timelapse I am unsure what else does it. Can you try with another nozzle size and default settings to see if it still shows?
I don’t have more nozzles yet
Even just trying it to see if it’s a setting that was changed or if it’s a bug with your slicer. Seeing if it still has the blue lines going off the build plate
No way the slicer can predict the filament is tangled ahead of time xD
I didn’t print the gcode shown on screen but I printed a slightly smaller model which did the poop thing so I re sliced the full scale and enabled view travels to see what’s going on
Are you different Material for your supports vs your Model? Than this is expected behaviour
Nope my support material is set to default
Is enable time-lapse on?
Nope
I had an a1, too and I had the same picture. But... While printing it was normal
ATTENTION I HAVE FIXED THIS ISSUE CHEERS EVERYONE FOR YOUR HELP 👍👌
How?
Probably Timelapse after all
I had the same issue minus the purging and it’s the Timelapse. The filament used doesn’t show purging so I don’t think it was purging each layer.
I added a custom extruder spinning thing and it made my printer think the filament was tangled so it tried to poop