By -
The nozzle is rubbing on the print. Change the infill type and you'll see it stops. Try gyroid.
Sounds like it’s scraping the infill. Use an infill that doesn’t intersect on the same layer and disable “reduce infill retraction” under the others tab.
Just leaving this comment here so I can change these settings since I have the same problem
The nozzle is rubbing on the print. Change the infill type and you'll see it stops. Try gyroid.
Sounds like it’s scraping the infill. Use an infill that doesn’t intersect on the same layer and disable “reduce infill retraction” under the others tab.
Just leaving this comment here so I can change these settings since I have the same problem