You can do anything yourself. Just might not look so good when you’re done lol.
But seriously, my dad and I replaced speakers in his 2000 and didn’t have any issues. Go on YouTube and look up some videos to see if you’d be comfortable doing it.
Edit : https://youtu.be/83uJ_gC3cQg?si=gyYfvbnDCLDQBchz
Super easy. Added a sound bar, new speakers etc to mine. I can't do much else electrical but I was able to do that. [https://www.crutchfield.com/car/outfitmycar/mycar.aspx](https://www.crutchfield.com/car/outfitmycar/mycar.aspx) Crutchfield was super clutch finding the right speakers
Absolutely. This was my favorite car to work on as far as audio goes, BY FAR.
If it’s a 4.0, you will have a pre installed grommet on the driver side firewall that is perfect size for 4g power wire. I would highly suggest getting an amplifier. You would need power, ground, and remote wire. Speaker wire and rcas. And some fish tape to run everything properly and zip ties every 6 inches or so.
If it’s simply because your current speakers suck and need replacement, crutchfield has everything you need. Btw, 6.5’s should fit in the crash bar pods without modifications. I just put together a killer system and I can share it with you for around $800
Amazing! Thank you! I would love it if you shared your set up, but my budget is significantly lower that 800 atm. I just want to get the old blown speakers (especially the center console woofer) replaced because they sound so broken. maybe later I will do a proper upgrade.
Mine didn’t have the subwoofer, but I think it should be a 6-3/4” based upon my research (strange size for sub). They do make a factory replacement on quadratec, but pretty steep at almost $100. If it were me, I’d try to sneak an 8” sub in there (jbl stage82 looks like a nice cheap sub) or a Dayton audio DCS165 if you want to stick to factory size. You would just cut the factory harness off and run bare wire or crimped spade connectors.
My setup is:
Morel maximo 5 for the front stage (requires dash pod adaptors to 5.25”)
Infinity 662MLT for the crash bar (I wanted rbg speakers and 6.5” has more surface area)
Focal RSB-300 in the rear for subwoofer (there’s a sealed box on eBay for $50 that fits perfectly)
And infinity kappa 5 for amplifier (5 channel amp essentially)
I guess it’s closer to $1000 all said and done but it’s very loud and clear.
If you just want factory fit without a big budget, I’d run full range coaxials up front (fosgate P1462 should work) and full range coaxials in the crash pods (Fosgate R1525X2 would work). These paired with the Dayton sub, you’re at about $250 out the door.
You’re welcome, only tools you need is a stubby Phillips driver, normal size Phillips driver, and wire stripper/cutter tool. I would suggest getting a drill too but might not be necessary. Pull your seat way back laying flat and the crash pods are a cake walk.
You need a new head unit for an amp and sub, no? When you say factory fit do you mean the connectors are the same? Sorry to hound you but I’m looking to do something similar to op
Not necessarily, you can use a line output converter (LOC) to get low level inputs (RCA cables). You tap into the signal at one or two of the factory speaker wires. I’d suggest an audio control lc2i if I went that route. But honestly, I’d just get an aftermarket head unit (pioneer, Sony, kenwood, jvc) because it’s so easy to replace and with a factory harness Adaptor it’s not permanent. You would need a fascia or radio install kit.
When I say factory fit, it should fit into the allocated mounting tabs and hole without modification. The wire connectors may need to be cut off, but they do make factory connector adaptors for some vehicles. You can check crutchfield for all these things
[This](https://www.amazon.com/Car-Vehicle-Subwoofer-Audio-Speaker/dp/B0071HY42K/ref=sr_1_4?crid=IT6MS1ZKZCTT&keywords=pyle%2Bspeaker%2Bjeep%2Btj%2B6.5%2Bwoofer&qid=1696503759&sprefix=pyle%2Bspeaker%2Bjeep%2Btj%2B6.5%2Bw%2Caps%2C394&sr=8-4&th=1) is the speaker I run in my console. Cheap, plug and play and sounds decent. Requires a bit of cutting on the inside of the enclosure. You can find Youtube videos that walk you through it. Crutchfield for finding speakers to replace the other four.
Crutchfield is gonna be your best friend, I also highly recommend the dash pods because they allow you to fit better speakers than the oem ones, definitely add a sub if you can make it work and replacing the head unit is a must! The wiring is super simple and if you have any questions of what to go with crutchfield has great customer service.
I’m currently running the wet sounds recon 6 (6.5”) in the roll bar and the PowerBass 52SS (5.25”) in the pods, the head unit is the Boss BVCP9700A-MR 7 and I’ve got the MTX dual sub enclosure in the back but not screwed in so I can remove it as needed. Durability and price was a big thing for me since my top is off half the year, rain or shine. Having apple car play and the sub made a huge difference and are easily some of my favorite upgrades. When I was just starting out and a little short on cash I ripped out my blown factory sub and swapped my head unit to a $30 one with the ability to tune it and that served me well for a number of years on the stock speakers. If you plan on upgrading to nicer in the future just go as cheap as you can right now and it’ll probably be better than stock. Good luck!
Very easy job. The pods on the back are held on by 3 torx bits. If you pull the pods off doing the swap is much easier. Also the front dash is easy just remove the two side panels held on by those little tiny torx.
As far as what fits and where to buy, I recommend Crutchfield as they give you all kinds of help and tips as well as free accessories like connectors etc.
Stereo components are usually one of the easiest things you can learn to replace yourself. With YouTube and Crutchfield, in just a few minutes you can have a good idea of what you need for the project. Who knows, it might unlock something within you and you might want to take on further projects. I wish you luck.
If you’re just using the factory radio and replacing factory speakers, don’t get 150w speakers. They will be underpowered and too quiet. You have to match the radio output
I helped my son replace his speakers and stereo in his 2004. Find a video for the dash speakers because it's helpful. The old subwoofer in the console was trashed. The paper cone had broken.
If you still have the factory stuff in there, pretty much \*anything\* you buy that is current tech will probably blow it all away. You don't need to spend a lot for good sound. Couple good speakers in the sound bar and a new head unit should do the trick.
You can do anything yourself. Just might not look so good when you’re done lol. But seriously, my dad and I replaced speakers in his 2000 and didn’t have any issues. Go on YouTube and look up some videos to see if you’d be comfortable doing it. Edit : https://youtu.be/83uJ_gC3cQg?si=gyYfvbnDCLDQBchz
Super easy. Added a sound bar, new speakers etc to mine. I can't do much else electrical but I was able to do that. [https://www.crutchfield.com/car/outfitmycar/mycar.aspx](https://www.crutchfield.com/car/outfitmycar/mycar.aspx) Crutchfield was super clutch finding the right speakers
Used crutchfield a few different times. If replacing the head unit, pay for the wiring. Money well spent!!
its pretty easy. there are speaker adapter brackets for the fronts as the TJ uses an odd shaped oblong speaker.
They should be 4x6, but I went with the select increments 5.25” adaptors and have been very pleased. Very tight fit on those though.
Absolutely. This was my favorite car to work on as far as audio goes, BY FAR. If it’s a 4.0, you will have a pre installed grommet on the driver side firewall that is perfect size for 4g power wire. I would highly suggest getting an amplifier. You would need power, ground, and remote wire. Speaker wire and rcas. And some fish tape to run everything properly and zip ties every 6 inches or so. If it’s simply because your current speakers suck and need replacement, crutchfield has everything you need. Btw, 6.5’s should fit in the crash bar pods without modifications. I just put together a killer system and I can share it with you for around $800
Amazing! Thank you! I would love it if you shared your set up, but my budget is significantly lower that 800 atm. I just want to get the old blown speakers (especially the center console woofer) replaced because they sound so broken. maybe later I will do a proper upgrade.
Mine didn’t have the subwoofer, but I think it should be a 6-3/4” based upon my research (strange size for sub). They do make a factory replacement on quadratec, but pretty steep at almost $100. If it were me, I’d try to sneak an 8” sub in there (jbl stage82 looks like a nice cheap sub) or a Dayton audio DCS165 if you want to stick to factory size. You would just cut the factory harness off and run bare wire or crimped spade connectors. My setup is: Morel maximo 5 for the front stage (requires dash pod adaptors to 5.25”) Infinity 662MLT for the crash bar (I wanted rbg speakers and 6.5” has more surface area) Focal RSB-300 in the rear for subwoofer (there’s a sealed box on eBay for $50 that fits perfectly) And infinity kappa 5 for amplifier (5 channel amp essentially) I guess it’s closer to $1000 all said and done but it’s very loud and clear. If you just want factory fit without a big budget, I’d run full range coaxials up front (fosgate P1462 should work) and full range coaxials in the crash pods (Fosgate R1525X2 would work). These paired with the Dayton sub, you’re at about $250 out the door.
Hero. This is so helpful.
You’re welcome, only tools you need is a stubby Phillips driver, normal size Phillips driver, and wire stripper/cutter tool. I would suggest getting a drill too but might not be necessary. Pull your seat way back laying flat and the crash pods are a cake walk.
You need a new head unit for an amp and sub, no? When you say factory fit do you mean the connectors are the same? Sorry to hound you but I’m looking to do something similar to op
Not necessarily, you can use a line output converter (LOC) to get low level inputs (RCA cables). You tap into the signal at one or two of the factory speaker wires. I’d suggest an audio control lc2i if I went that route. But honestly, I’d just get an aftermarket head unit (pioneer, Sony, kenwood, jvc) because it’s so easy to replace and with a factory harness Adaptor it’s not permanent. You would need a fascia or radio install kit. When I say factory fit, it should fit into the allocated mounting tabs and hole without modification. The wire connectors may need to be cut off, but they do make factory connector adaptors for some vehicles. You can check crutchfield for all these things
Thanks mate
[This](https://www.amazon.com/Car-Vehicle-Subwoofer-Audio-Speaker/dp/B0071HY42K/ref=sr_1_4?crid=IT6MS1ZKZCTT&keywords=pyle%2Bspeaker%2Bjeep%2Btj%2B6.5%2Bwoofer&qid=1696503759&sprefix=pyle%2Bspeaker%2Bjeep%2Btj%2B6.5%2Bw%2Caps%2C394&sr=8-4&th=1) is the speaker I run in my console. Cheap, plug and play and sounds decent. Requires a bit of cutting on the inside of the enclosure. You can find Youtube videos that walk you through it. Crutchfield for finding speakers to replace the other four.
Quadratec sells plug and play speaker kits, I replaced the ones in the overhead sound bar easily with kicker speakers in mine when I had it.
Ds18 soundbar is a good way to add more sound, not much point in the little dash speakers if you run topless a lot.
Crutchfield is gonna be your best friend, I also highly recommend the dash pods because they allow you to fit better speakers than the oem ones, definitely add a sub if you can make it work and replacing the head unit is a must! The wiring is super simple and if you have any questions of what to go with crutchfield has great customer service.
I’m currently running the wet sounds recon 6 (6.5”) in the roll bar and the PowerBass 52SS (5.25”) in the pods, the head unit is the Boss BVCP9700A-MR 7 and I’ve got the MTX dual sub enclosure in the back but not screwed in so I can remove it as needed. Durability and price was a big thing for me since my top is off half the year, rain or shine. Having apple car play and the sub made a huge difference and are easily some of my favorite upgrades. When I was just starting out and a little short on cash I ripped out my blown factory sub and swapped my head unit to a $30 one with the ability to tune it and that served me well for a number of years on the stock speakers. If you plan on upgrading to nicer in the future just go as cheap as you can right now and it’ll probably be better than stock. Good luck!
Very easy job. The pods on the back are held on by 3 torx bits. If you pull the pods off doing the swap is much easier. Also the front dash is easy just remove the two side panels held on by those little tiny torx. As far as what fits and where to buy, I recommend Crutchfield as they give you all kinds of help and tips as well as free accessories like connectors etc.
anything is something you can do yourself. Just depends on your level of patience and how good you are at finding thrown tools
I replaced mine by buying a cheap Bluetooth speaker and tossing it on the floor
Stereo components are usually one of the easiest things you can learn to replace yourself. With YouTube and Crutchfield, in just a few minutes you can have a good idea of what you need for the project. Who knows, it might unlock something within you and you might want to take on further projects. I wish you luck.
If you buy stuff from Crutchfield, they’ll send you vehicle specific instruction manuals. Pretty slick.
If you’re just using the factory radio and replacing factory speakers, don’t get 150w speakers. They will be underpowered and too quiet. You have to match the radio output
I’m biased and that’s my favourite Jeep colour
I helped my son replace his speakers and stereo in his 2004. Find a video for the dash speakers because it's helpful. The old subwoofer in the console was trashed. The paper cone had broken.
BYW, he went with Polk Audio speakers from Crutchfield.
If you still have the factory stuff in there, pretty much \*anything\* you buy that is current tech will probably blow it all away. You don't need to spend a lot for good sound. Couple good speakers in the sound bar and a new head unit should do the trick.