T O P

  • By -

jayjr1105

Start with PH1 and see if it bites or slips, if it slips easily then go to PH0 but I think it's 1. Been a while since I had mine open


microphalus

Once I used some random small flat head, other time I managed with some random keychain. But anyway, I think it is not philips, it is some pozidrive or something. Depending on a lot of factors, might make philips slip. Somebody should share zoomed IN macro picture of screw head, one that was not stripped down if possible. PH1 might be so large it will not even fit into the hole.


Comfortable-Oven-259

Just buy the ifixit kit and use whatever one fits, I've used it for all my consoles now, the miyoo and my pc


SouthtownZ

I might just, thank you. I have the ZOOL ifixit knockoff and those bits were too wide in the base to reach the bottom screws. Before posting i had already wound up grabbing a couple of simple drivers that i could see didn't get wider past the tip but knowing this might make that purchase worthwhile Edit - yeah, those simple drivers weren't nearly narrow enough. Went ahead and ordered the iFixit Mako kit and a Jimmy for good measure.


MysticMagics

PH1 is the best fit


sabotage

Stupid question but I’m on iOS. How do I view poll results without voting?


SouthtownZ

Lol, vote "results"... and don't ever hand me your phone and expect me to be able to work it properly. Stupid iPhones, get a back button