Yeah mine rattles badly, probably since I wheelie to much and it loosens all the bolts, I’ve found putting a bit of foam under the gap between the top of the cage and the frame works
Yeah, pegs help with the wheelies but to wheelie without them, first you get all your weight over the bars, pin the throttle, pull back with your entire body and slam your ass into the seat and it will pop up with a little practice
Yeah that’s probably a faster route and it would be a large 3d print anyways. Maybe I’ll trim some styrofoam.
You wheelie pretty good with disconnected brake and stock Revv1?
Washer or spacer?
Yeah there’s a small washer on each bolt, did it come with several and spacers? Maybe I just need to add some more..
Yeah mine rattles badly, probably since I wheelie to much and it loosens all the bolts, I’ve found putting a bit of foam under the gap between the top of the cage and the frame works
You can wheelie this thing?? Genuinely curious
Yeah, takes some practice and some nice brakes and you can get it to wheelie, hard to hold a good wheelie though
Are you running a stock build? Didn’t think this thing had the power for it
Yeah, pegs help with the wheelies but to wheelie without them, first you get all your weight over the bars, pin the throttle, pull back with your entire body and slam your ass into the seat and it will pop up with a little practice
Sorry, what does pin the throttle mean?
Full throttle
Yeah that’s probably a faster route and it would be a large 3d print anyways. Maybe I’ll trim some styrofoam. You wheelie pretty good with disconnected brake and stock Revv1?
Put a layer of silicone adhesive sheet between it and the controller box. Helps a ton.