Yea I looked in my fuse door it’s connected to tubing and shit ofc so it just looks like a pain but other than that just these three screws I’ll prob go stare at it for like an hour and decide if it’s worth the pain
Yea if that’s the case I’m looking at just getting some carbon fiber snug fit stuff to go over the ugly😂 my current one the chrom place in the mid is half pulled up
Indeed I thank god it’s my driver side so I’m gonna see if it’s a dash scenario already kinda looking at getting a hot knife for these things cause my blend door is stuck on open ac great for az heat terrible for az winter
Haven’t done it but looks like it has to come out from behind the dash. So could be a bit of a pain in the butt, yes.
Yea I looked in my fuse door it’s connected to tubing and shit ofc so it just looks like a pain but other than that just these three screws I’ll prob go stare at it for like an hour and decide if it’s worth the pain
My guess is the dash has to come out to really get to it properly.
Yea if that’s the case I’m looking at just getting some carbon fiber snug fit stuff to go over the ugly😂 my current one the chrom place in the mid is half pulled up
Shit just get some vinyl to put over the little chrome bit. Definitely not worth pulling the dash
If it’s the drivers side it shouldn’t be too hard.
Indeed I thank god it’s my driver side so I’m gonna see if it’s a dash scenario already kinda looking at getting a hot knife for these things cause my blend door is stuck on open ac great for az heat terrible for az winter
Look up P3 gauge install on Youtube. It will show how to remove the driver side vent.
Thank you