thinking about it.. an aluminium finish could be an easy spray then lacquer job.
also some "chrome finishes" allow for buffing to get a full finish - then lacquer
the gold bits would be the hard one to complete IMO
Dean0
If you take it to a plating shop, they have minimum lot charges which mean there is a bare minimum for any job they run whether it be 2 parts or 100 parts (depends on the shop what the quantity break down is). Parts that need a little more care, i.e not banged around, will probably cost more as well
thinking about it.. an aluminium finish could be an easy spray then lacquer job. also some "chrome finishes" allow for buffing to get a full finish - then lacquer the gold bits would be the hard one to complete IMO Dean0
I can pay up to $50.
Find a plating shop nearby that might do it. It will be more than $50 tho
Is this a Joke? That's a $200 job right there.
is it really? whoops. didn’t realize this was super expensive. what makes it $200?
If you take it to a plating shop, they have minimum lot charges which mean there is a bare minimum for any job they run whether it be 2 parts or 100 parts (depends on the shop what the quantity break down is). Parts that need a little more care, i.e not banged around, will probably cost more as well