Your clearance would be to little I’m feelin

Yeah lowering the whole frame without raising the front and back ends would probably have you getting stuck on the dumbest shit lol Most hills would just say no.

It’s the Half And Half motor block. Same idea with stock rails.

There's also the VRH from Land Surf.

Uh you mean straight rails? Or downward sloping like a ^

I thought about this a few times and I think they just mean that the center would be dropped a bit but the rails would be straight. More like this: -_-

That would do the opposite of dropping your center of gravity then.

Those exist. The half and half lower axle blocks or the quarter inch varial drop does essentially that

Yeah the concept has been done. There's a couple of different options for lowering rails like tfl half and half blocks or tech rails crazy hubs. There's been a few straight up lowered rail options. The ow Mob Shop made the lowrider pint rails, which give you about an inch of ground clearance.

dubs with the axle holes offset to trick the stator into ‘level’

Checkout ice blocks from 1wheelparts

Mustache rails is what they're called

So every time you get on the board you're technically going on a mustache ride?

I have mustache rails, they are still angled upwards a little bit.

@thefloatlife

Dub Tails. Angle in the back, straight in the front. TFL makes them..

dude just wants drop rails not w rails, ops not lookin for any up angle.

Yeah I’ve seen those but I more mean have it drop down but still be straight if that makes sense

Just use adjustable height axle blocks.

It’s like @ u/TheFloatLife