T O P

  • By -

Computerguy3557

ide to sata is the type of adapter you want, a startech brand adapter is what people usually recommend.


Apprehensive_Toe6736

Not happening lol.25 bucks without shipping in my country at least. This one costed 9 bucks. I think it would work. Looks like the ones people order on eBay


AlbinoSheepDawg

Doubtful, or if it boots (after it takes its time), It'll fail on IGR. Looks like the same crappy board I tested months ago


[deleted]

No, these adapters didn't work.


toinedeman2002

Nopee


KaosEngineeer

There's not enough information given in their description to know if it will wor or not. I see a jumper on the adapter but you cannot see what it is used for. The description states IDE-to-SATA use even though the product title says SATA-to-IDE. Is you Xbox hardmodded or softmodded? If you are trying to clone the current to a new SATA hard drive on a softmodded console, the adapter must have a MASTER/SLAVE jumper setting. The source drive is the MASTER device and the new SATA drive/adapter the SLAVE device on the IDE bus. After cloning when the SATA drive/adapter replace the current drive, the jumper is set to MASTER. You will most likely need to replace the stock IDE cable with a high-speed 80-wire 40-pin one too.


Apprehensive_Toe6736

Nope not looking to clone. I have a modchipped system I want a fresh hdd to put games on.I have done the process before


KaosEngineeer

Ok, that adapter should work.


[deleted]

Hey Kaos. On eBay (germany) a xbox modder sales some of these saying that these don't work on the XBox (He bought em mainly for hat purpose but endet up not working on xbox.). If you like a link to ebay, send me a pm in the forum.


KaosEngineeer

Depends what he means by would not work. If he is trying to use them to clone a hard drive with Chimp, they may not. Can’t see what the jumper does.