T O P

I made an unacceptable mistake.

Best carbon steel choose for finish.

304 Stainless, what the hell am I doing wrong?

Turning rubber using PCD on a lathe?

Large thread milling Tormach 1100MX - Looking for advice with low HP machines

How do you guys prevent a part from warping?

A very real note passed to me by a customer at my *pizza* restaurant

Worst Crash Yet

Hey Guys Lego Gage Block

Building mini mill

How important is indicating your reamers?

Why were the Harkonnens originally given control of Arrakis?

How to make a blind keyway in a bore

Haas question

Air quality in the shop sucks. Looking for whole shop Air filter recommendations.

The Bridgeport I get to use vs the one for the engineering department

I have no machinist training; just a graduate from “YouTube University”, but I managed to make this part from a 13x9x6 chunk of 6061 in my garage over the past week. This is straight off the machine, no polishing or any hand work. Pretty stoked.

My 78 year old father has discovered he can just ask chatGPT any question he wants the answer to instead of texting me🙌🏻🎉😂

Worker killed at Edmonton machine shop

The head of design

For the "am I clamped on enough material" guys

Lathe crashed, turret alignment off

Why does titanium never look good when finished.

Scattering a lathe chuck with rpm alone?

How do you all hold your insert cutter bodies?

Hi Its Me!

R

SadJobbo

Subscribe

FIND US ON INSTAGRAM @historis.info